Shop

28BYJ-48 Stepper Motor and ULN2003 Stepper Motor Driver

In stock

This 5V DC 28BYJ-48 Stepper Motor is a small, inexpensive, and high-quality geared step motor. The 28BYJ-48 Stepper Motor and ULN2003 Stepper Motor Driver is a widely popular combination of the stepper motor and stepper driver, because of the stability and reliability of the system.

Thia 28BYJ-28 stepper motor is imported from one of our trusted suppliers and the supplier has guaranteed the quality of these compact stepper motors.

Add To Quote

2CH 27MHZ with Antenna KIT

In stock

Introducing the Electronic Frequency Remote Control Transmitter and Receiver Board Set! This cutting-edge remote control system operates on a stable 27MHz frequency, ensuring seamless and reliable communication between the transmitter and receiver. With an impressive antenna length of approximately 26cm (10.24in) for the transmitter board and 18.5cm (7.28in) for the receiver board, you can enjoy an extended remote control range for your projects.

Add To Quote

2DOF MG996R Industrial Servo Gripper

In stock

  • Aluminium light weight good strength metal parts
  • High Torque metal geared MG996R servo motors
  • All joints Assembled with Bearings for smooth and precession rotation
  • Spacers
  • Smooth rotation
Add To Quote

2S 3A BMS

In stock

  1. Over-Discharge Detection Voltage: 2.3-3.0V±0.05V.
  2. Maximum Working Current: 3A.
  3. Transient Current: 5A.
  4. Operating Temperature : -40-50 C.
  5. Internal Resistance: Less than 45m Ω.
  6. B+ B-: The interface of battery core.
  7. P+ P-: The connector of the battery board.
  8. MB: The connection point between the batteries.
Add To Quote

2S 8A BMS

In stock

Main function: overload protection, discharge protection, short circuit protection, overcurrent protection function.

Use: 2-chain lithium 7.4V Lipo Li-ion 18650 phosphate battery rechargeable battery pack.

Add To Quote

2S BMS 10A Round

In stock

  1. It is safe and reliable to use.
  2. Small and compact.
  3. Easy connections.
Add To Quote

2S BMS 7.4V-20A

In stock

BMS (Battery Management System) – a battery management system that is designed to monitor the status of batteries, control the process of charging/discharging the battery, etc.

  1. Small size designed for a four-cell battery pack.
  2. Simple and  convenient circuit for easy connections
  3. Over-charge/Over-discharge Protection.
Add To Quote

2W KIT ( SINGLE BOX PACK )

In stock

This is 2 wheel smart car robot chassis DIY kit. It comes with the 2 pairs of BO Motors and Wheels. All the products included in this car kit are quality products. The chassis used in this kit is transparent so as to create dynamic handling of the components mounted on your robotic vehicle.

Add To Quote

2WD Red Metal Chassis

In stock

  1. Available in two color red & grey ( We will ship randomly)
  2. Many perforated holes have given for easy attachment of the development board and sensors
  3. Center Shaft gear motor and side shaft gear motor can be used for this chassis.
Add To Quote

3 in 1 Aluminum Heat Sink Set for Raspberry Pi 3/4

In stock

It is a set of 3/4 Raspberry Pi heatsinks suitable for applications on Raspberry Pi 3/4 Model A/A+/B/B+. The bigger one is to be used on the Broadcom microprocessor itself while the other is for the Ethernet Controller IC. The 3rd one acts as a spare. These high-quality aluminum Raspberry Pi heatsinks also have a self-adhesive paste helping you to install the heatsinks with ease just peel the backing and put it on the top of the IC and it’s done. It helps in thermal transfer thus reducing the risk of hardware failure even while the Pi is being overclocked. So that you don’t have to worry about burning up your board while overclocking to perform complex tasks under high power usage.

Add To Quote

3 PIN TOP RELAY 12V ( COVERED) T93

In stock

The 3-pin 12V T93 relay is a compact electromechanical switch used in various electronic circuits. It typically operates on a 12-volt power supply and features three pins for easy connection. This type of relay is commonly employed in automotive, industrial, and consumer electronics applications for tasks such as controlling lights, motors, and other electrical components.

Add To Quote

3 V TOY MOTOR GATTU (32 X 23MM)

In stock

Using high hardness steel, good toughness, impact resistance, the quality of the bearing and the service life of the gear motor are improved, extremely durable.

Add To Quote

3 W Robot Smart Car DC Motor DIY 3-6V, For Robotics

In stock

DC Gear Motor Dual Shaft DIY Kit for Arduino Smart Car Robot

Add To Quote

3 Wires 0.28 inch Digital Voltmeter DC 0-100V Red Light LED Panel Voltage Meter

In stock

The meter requires extra power supply of DC 4.0 to 40V.
Its resolution is 0.1V and its actual error might larger than 0.1V. “

Add To Quote

3-1/2 DIGIT 2000 COUNTS 600A AC AUTORANGING DIGITAL CLAMPMETER

In stock

  1. Material: Bronze, Plastic
  2. Display Type: LCD
  3. Number of Counts:2000
  4. LED Indicators: No
  5. Audible Continuity Test: Yes
  6. Data Freeze: Yes
  7. Autoranging: Yes
  8. Reading Storage: Yes
  9. Backlight: Yes
  10. PC Connectivity: No
Add To Quote

3-In-1 ACEBOTT ESP32 STEM School Smart Home Education Kit – LV 1

In stock

The ACEBOTT STEM School Smart Home Kit Education Solution Series with Teaching Resource for Arduino/ESP32 is ideal for children aged 8 and up who want to learn programming and electronics. It uses the ESP32 controller board to make it simple for beginners to start coding. With this kit, kids can build and explore smart home projects like smart lights, entertainment systems, and temperature control. It’s a fun way to learn and get creative.

The kit also comes with a clear, step-by-step guide and 90 minutes of helpful teaching materials. Made from safe, eco-friendly plywood, it’s easy to put together and can even be colored for a personal touch. It’s a great choice for schools or as a special gift for young learners, helping them develop important skills while having fun.

Add To Quote

3.2 inch TFT LCD Screen Module

In stock

The Display comes with 240×320 pixels with individual pixel control. It has way more resolution than a black and white 128×64 display.  As a bonus, this display has a resistive touchscreen attached to it already, so you can detect finger presses anywhere on the screen.

Add To Quote

3.2 Inch TFT LCD Touch Screen Display V4.0

In stock

This is all-new Version 3.2 Inch TFT LCD Touch Screen Display V4.0 for Raspberry Pi from waveshare is big (3.2″ diagonal) bright and colourful! 240×320 pixels with individual RGB pixel control, this has way more resolution than a black and white 128×64 display.

Add To Quote