3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model

This is a 3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model.

This is Mega Pololu Shield or RAMPS for short. The 3D Printer Controller Board RAMPS 1.4 is designed to fit the entire electronics needed for a RepRap in one small package for low cost. RAMPS interfaces an Arduino Mega with the powerful Arduino MEGA platform and has plenty of room for expansion.

11 People watching this product now!

6000 +

Products

10:00am - 7pm

Working Hours

Genuine Products

Guaranteed

Description

  1. Standard interfaces (as that of the extruder)
  2. Reserved GCI like I2C and RS232
  3. MOSFET 3 MOSFET is applied to the heater/ fan and thermistor circuit.
  4. Another 5A added to protect the component parts.
  5. An 11A fuse is added to the hotbed.
  6. Support 5 stepper drive board
  7. The adoption of Pin Header as Pololu makes it more convenient to repair or change.
  8. I2C and SPI are reserved for expanding
  9. All the MOSFET can be controlled by PWM
  10. Use the interface of the servo motor to adjust the level of the printing platform automatically.
  11. Adding an SD module for SD ramps module.
  12. LED can indicate the status of the heater (the open and close of MOS).
  13. Expandable to control other accessories.
  14. Pololu boards are on pin header sockets so they can be replaced easily or removed for use in future designs.
  15. 2 stepper motor for Z axis in parallel.
Additional information
Height (mm)

26

WEIGHT

60

Shipping Dimensions

12 X 6 X 4 CM

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “3D Printer Controller Board RAMPS 1.4 Arduino Mega Shield RepRap Prusa Model”

Your email address will not be published. Required fields are marked *